Noise Management

Federal Aviation Administration (FAA)
The FAA has primary responsibility for the movement of aircraft both within the airport movement area (taxiways, runways) and in the air. Air transportation affects interstate commerce; therefore, it falls under the regulatory responsibility of the federal government. The FAA designs standard air traffic procedures based on various safety, capacity, and traffic flow management considerations. Safety remains the first priority of Air Traffic Control (ATC).

The FAA also designs criteria and guidelines governing the analysis of noise exposure resulting from aircraft operations at U.S. civilian airports. The agency requires compliance with federal standards for all federally-funded noise compatibility studies and noise mitigation programs. Overall, the FAA is responsible for regulatory actions governing aircraft noise certification, noise phase-out programs, and aircraft operational restrictions.

Houston Airport System
Houston Airports serves as the landlord of its airports, holding leases with airlines, concessionaires and airport-related businesses. While airport managers and staff regulate activities such as engine maintenance run-ups, they do not have authority to alter flight tracks and airspace procedures. Houston Airports can advocate noise mitigation practices and operational procedures to contain noise exposure, but actions of the sort require approval and implementation by the FAA.

Airlines
Airlines are users of the airport and airspace system. They determine their own schedule, frequency of operation, which markets to serve, what fares to charge and types of equipment to operate. They do so in compliance with federal aircraft certification and operating requirements. In addition to active Federal Aviation Regulations, airlines also set their own standard operating procedures based on best business and operating practices.

Pilots
Pilots have the ultimate responsibility for the safe operation of the aircraft. Although each airline can adopt voluntary mitigation procedures and recommended best practices, pilots still retain the operational authority and discretion to make final decisions regarding the safe operation of the aircraft. Pilots are expected and encouraged to adhere to special operational procedures during departure and arrival. However, in the interest of safety, pilots may deviate from such procedures when necessary.

Even though each runway can be used for takeoffs or landings, IAH has primary flow patterns when conditions permit. The graphics shown below represent typical departure and arrival corridors in two airport configurations due to prevailing wind conditions: West-Flow and East-Flow. Note that wind conditions can shift within the same day or persist over several days. Therefore, the airport can experience multiple flow configurations during the same day or register one persistent flow for several days before a shift in wind conditions occurs.

If you have questions about a particular flight pattern over your home, please contact the Noise Compliance Office at 1-281-233-3900.

What happens when I report aircraft noise?

The Noise Compliance Office will log your report in a database. Each report is investigated and a follow-up response is provided when requested. Should it be determined that an aircraft in question was not following an established Federal Aviation Administration (FAA) procedure, the FAA and/or the airline will be notified in order to take corrective measures.

Why do planes fly over my house?

Depending on where you live, aircraft may be flying overhead as a result of standard airspace control procedures. However, day-to-day airfield maintenance or weather conditions may change traffic flow patterns.

For safety reasons airplanes land and  take off into the wind and must follow standard instrument procedures and/or Air Traffic Control (ATC) vectoring and sequencing instructions. Arriving aircraft will typically line up with the runway many miles away, then make their final decent approach to the runway via a three degree glide slope from the runway end. This translates to about 300 feet of decent altitude for every mile flown. In other words, if an aircraft is three miles from the arrival end of the runway, its altitude will be approximately 900 ft.

Why do some planes fly lower than others?

Aircraft have different climb capabilities due to their varying sizes, payloads, engines and aerodynamic performances. For instance, a departing heavy jet aircraft will typically have a slower climb rate than that of a small light jet aircraft. On the other hand, aircraft arriving at IAH will generally have an approach altitude assigned by ATC many miles out before landing and, due to separation requirements, each aircraft will be assigned different altitudes as they simultaneously approach the airport side by side. Large aircraft will often appear lower and slower than smaller ones even though they are at the same altitude and air speed.

Who controls aircraft flight paths?

The FAA is solely responsible for the vectoring and sequencing of aircraft within Houston's airspace and on the ground within each airport. The primary responsibilities of ATC are to ensure the safe and efficient operation of aircraft.

Can the noise office change flight paths?

No. Although the FAA and the Houston Airport System coordinate activities frequently, airspace control and management is the sole responsibility of the FAA. Any change in departure or arrival flight paths can only be approved and implemented by the FAA.

What are Stage 1, Stage 2 and Stage 3 aircraft?

This is an FAA system used to determine and certify the noise level of an aircraft based on weight, number of engines and, occasionally, its passenger capacity. Aircraft noise levels are certified as Stage 2, 3, or 4. Any aircraft that predates this system and was never tested and certified is classified as noise level Stage 1.

Stage 1 aircraft are the oldest and the noisiest, and are not permitted to operate in the United States if their certified weight level exceeds 75,000 pounds. The earliest Learjet aircraft are Stage 1.

Stage 2 includes aircraft such as the B-727, B-737-200, and the DC-9. Stage 2 aircraft were required by law to be modified with “hush kits” to meet Stage 3 noise levels or be phased out of service by January 1, 2000.

Stage 3 aircraft are on average about 10 decibels (dB) quieter than a comparably-sized Stage 2 aircraft. These aircraft include the Boeing 737-800, 757 and 767; the Airbus 320; and the MD 80/90. Some of the older Stage 2 aircraft were re-fitted or “hushkitted” to meet Stage 3 standards.

Stage 4 noise level standards were recently recommended for future manufacture of new aircraft by the Committee on Aviation Environmental Protection of the International Civil Aviation Organization (ICAO). There is no requirement at the present time for a stage 3 phase-out. The Stage 4 standard insures that, over time, future aircraft types will be quieter.

Can the airport restrict a particular type of aircraft from flying over specific neighborhoods?

No. The airport cannot restrict access to various aircraft types nor  impose operational restrictions outside of federally-mandated requirements such as those enacted for the 2000 phase-out of stage 2 aircraft. Note that in 2000, the federal government completed the phase-out of all stage 2 aircraft weighing more than 75,000 pounds.

Will aircraft become quieter?

Newer aircraft currently being manufactured are much quieter than older aircraft. Many already meet stage 4 requirements recommended recently by the International Civil Aviation Organization (ICAO). For example, the new Boeing 777 is one-tenth quieter than the older Boeing 727-200, yet it can carry twice the number of passengers.

The advent of high-bypass turbofan engines in the  1970s marked a significant improvement in aircraft noise emissions (15-20dB reduction). The chart below illustrates the significant gains made in source noise reductions since the entry of second-generation turbofan engines in the industry.